5 Killer Quora Answers To Fiat 500 Replacement Key Cost

fiat key fob replacement 500 Replacement Key Fob

If your 500 remote key fob has stopped working, it might be time to replace the battery. If you do replace the battery but it is still not working, then the problem is likely to be elsewhere.

United Locksmith specializes in the creation of new keys for classic cars. We have the tools and spare parts required for this type of service.

Dead Coin Battery

The most common reason why your Fiat 500 key fob will not unlock or lock the doors is due to a dead battery. The key fob is equipped with a coin cell battery that will drain quickly when it isn't frequented enough. If your remote started to show signs of weakening like a loss of range and then completely stopped working it is likely that the battery is dead.

Metal clips keep the battery in on the key fob. If the clips are loose, they could cause problems with contact, which can prevent your remote from receiving power. Use a flathead screwdriver remove the retaining clip and remove the old battery. Use a battery that has the same voltage, size, and specification as the original.

The exposure to water can cause the key fob to become corroded or damaged. Even a quick shower in soapy water can harm the electronic chip in. Keep your key fob dry.

Water Damage

If your key fob isn't functioning properly, it could be caused by water damage. The rubber seals on key fobs prevent them from being damaged by a slight splash or drizzle of water. However, it is crucial to keep the keys from the washing machine, the ocean, and pool.

The key fob has an electronic chip which sends a message to the immobilizer system of your vehicle. This is what allows your 500 to start or lock, however when the chip becomes wet, it's unable to longer work.

Try cleaning the inside electronics of your keyfob with isopropyl alcohol or an electronic cleaner to see whether they're still in good condition. It is recommended to replace the key fob when it has been submerged into salt water instead of trying to repair it yourself.

A replacement fob may cost you a bit however, it's less expensive than paying to have your Fiat 500 towed to a dealer and repaired there! You can also do it yourself with the simplest of steps. Just ensure you have the right battery type before you attempt to open your key fob. You can find step-bystep instructions for any car keyfob on the internet.

Faulty Chip

The chip in the key fob communicates directly with the immobiliser in your vehicle to ensure that the vehicle will start only when the right keys are in place. If the chip is damaged or destroyed, your car won't start, no matter what you do.

Water damage or a dead cell phone battery are among the most common reasons for defective chips. Whatever the reason, it's a good idea to leave the work to a locksmith who can replace the chip quickly and at a cost-effective price.

If your key fob does not function after being exposed to water that is clean from the tap or rain take it off the battery. Wipe down the electronic component with a paper towel. If the key fob does not function, there's an opportunity that it is a fried component and needs to be replaced.

Some people will go to their dealer if they require a new fiat 500 key replacement cost - http://fpcom.co.kr/bbs/board.php?Bo_table=free&wr_id=490967 - fob. However, this could be costly. United Locksmith is the best place to go if you are looking to have your Fiat key fob replaced at a reasonable cost. We have the tools and experience required to repair your Fiat key fob in a timely and professional way.

Faulty Receiver Module

Fiat key fobs transmit an electrical signal to the vehicle that can unlock and close doors (and start the vehicle for those with an automatic transmission) up to 50 feet. However there are a few things that can cause the fob to stop functioning. This could be due to a dead coin battery, water damage buttons, worn ones as well as a receiver module problem and signal interference or a malfunctioning electronic chip.

If the fob was located in an area that has experienced severe trauma (such as being dropped onto the hard floor or washed in a washing machine), it may not be in a position to connect with the Body Control Module (BCM) of the vehicle. The BCM is a security device that will only accept signals from genuine original keys.

If this is the case, you must replace your fob. A professional locksmith will handle the entire key replacement process including programming a new key to your 500. In fact, they can even provide you with a clone key that functions like the original fob (and costs only a fraction of the price).